Buildstyle is a set of parameters that communicates with a printer on how to process the material it is printing.
Tip: See Install Buildstyle Envision One RP for instructions connecting a new buildstyle to Envision One RP Software. See Printer Calibration for instructions calibrating your new buildstyle.
All released D4K Pro buildstyles for Dental Materials are available for download below:
-
D4K_385nm_E-Guard ET_100µm_vertical orientated.bs
40 KB Download
-
D4K_385nm_E-Guard ET_100µm_horizontal orientated_v1.0.bs
40 KB Download
-
D4K_385nm_E-Guide ET_100µm_vertical orientated.bs
40 KB Download
-
D4K_385nm_E-Model Light DLP_50µm_v1.0.bs
40 KB Download
-
D4K_385nm_E-Gum_100µm.bs
40 KB Download
-
D4K_385nm_E-Guide ET_100µm_horizontal orientated_v1.0.bs
40 KB Download
-
D4K_385nm_E-IDB_100µm_v1.0.bs
40 KB Download
-
D4K_385nm_E-Model Light DLP_100µm_v1.0.bs
40 KB Download
-
D4K_385nm_E-Splint Soft_100µm.bs
40 KB Download
-
D4K_385nm_E-OrthoShape_100µm.bs
40 KB Download
-
D4K_385nm_E-Tray_100µm.bs
40 KB Download
-
D4K_385nm_Flexcera Base_100µm.bs
50 KB Download
-
D4k_385nm_Flexcera Smile Ultra+_50µm.bs
50 KB Download
-
D4K_385nm_Flexcera Smile_100µm.bs
50 KB Download
-
D4K_385nm_Flexcera Smile Ultra+_100µm.bs
50 KB Download
-
D4K_385nm_FreePrint Denture+_100µm.bs
40 KB Download
-
D4K_Model_X_50µm_v1.3.bs
50 KB Download
-
D4K_385nm_NextDent C&B MFH_100µm.bs
40 KB Download
-
D4K_385nm_NextDent Denture 3D+_100µm.bs
40 KB Download
-
D4K_385nm_NextDent Try-In_100µm.bs
50 KB Download
-
D4K_Model_X_75µm_v1.3.bs
50 KB Download
-
D4K_Model_Z_100µm_v1.0.bs
50 KB Download
-
D4K_385nm_KeySplint Soft_100µm_v1.6.bs
50 KB Download
-
D4K_385nm_Press-E-Cast_LED_50µm_v1.bs
50 KB Download