Manual Debris Removal is a software feature that helps protect the surface of the material tray by exposing a thin layer of material. When the exposed layer is peeled away, a clean material tray surface is left. This feature only removes debris stuck to the surface of the material tray – for debris floating in the material, the material will need to be filtered.
To use the Manual Debris Removal feature:
2. Set the required exposure time using the + and – icons. The time is material-dependent, though a 15-second exposure time works well for any material.
3. Press Expose.
→ The whole material tray area is exposed.
4. Remove debris from the material tray by simply taking off the thin film of the exposed material.
5. Proceed following the step-by-step for filtering material described on the Maintain Materials page, if needed.