To detach printed models from the build platform, proceed as follows:
1. Place the build platform on its side in the processing zone as shown in the diagram below. Watch the material so it doesn’t leak into the build platform cavity.
Important: Ensure the magnet on the build platform stays clean. Do not bump or scrape the magnet.
2. Hold the build platform handle with one hand to steady the platform.
3. Use the scraper from the Starter Kit to gently detach models from the build platform. Angle your tool roughly 30 degrees from the platform and move the blade while applying a slight amount of pressure.
Notice: If the model doesn’t begin to separate easily, move to a different area on the model, working your way around the model until it safely dislodges from the build platform.
Place each model on a paper towel to catch the excess material as it drips.
Tip: Note that the models appear to be glossy. This is because uncured material is covering the surface.