 CAUTION |
Risk of damage to the printer: Do not adjust the position of the level sensor. This may result in false readings to the sensor and cause print failure. |
Time needed: Approximately five minutes
Maintenance frequency: Bi-weekly
Overview
The level sensor reads and via the level compensator adjusts the material level in the vat. It is critical that the sensor is always clean and free from any dust particles and material that may have splashed or dripped on the sensor lens.
The level sensor is located on the back right side of the front main compartment. It has a red dot right under it.
Supplies Needed
- Lens Cleaner
- Clean Microfiber cloth
Step-by-step:
- Spray some lens cleaner on the microfiber cloth and gently wipe the bottom of the sensor.
- Wipe the bottom of the sensor again with a dry section of the microfiber cloth. Make sure to wipe away any streaks that may still be present.